Phased Array Ultrasonic Calibration Block:

APPLICATION: Phased Array “Type A” Calibration Block is used during the initial setup and calibration of phased array Ultrasonic Unit , This Block can be used to perform task such as beam angle verification , Calibration for Wedge Delay, Sensitivity Calibration, Performing DAC/TCG AND more

MATERIAL: ? Carbon steel, Stainless Steel, aluminum etc.

INCH VERSION DIMENSIONS: ? 1.000” thick x 4.000” Hight x 12.00” Long ? 4.000” and 2.000” Radii, 19 through holes at 0.040” diameter , 1 through hole at0.080” Diameter , 4FBH at 0.80” diameter x0.080”, 0.160”, 0.235” and 0.315” deep, 4FBH at 0.157” Diameter x0.040”, 0.120”, 0.200” and 0.275” Deep, 3FBH at 0.080” Diameter x 0.120 Deep machined into the 2.000” Radius, 4EDM Notches at .004”, .008”,.012” and .016” deep x 0.20” wide x1.00” Long,

METRIC VERSION DIMENSIONS: ? 25.0mm thick x 100.0mm Hight x 300.0mm Long ? 100.0mm and 50.0mm Radii, 19 through holes at 1.0mm diameter, 1Through hole at 2.0mm diameter , 4FBH AT 2.0mm diameter x2.0mm, 4.0mm, 6.0mm an d8.0mm deep, 4FBH AT 4.0mm diameter x1.0mm, 3.0mm, 5.0mm and 7.0mm deep 3FBH AT 2.0mm diameter x 3.0mmdeep machined into the 50mm radius, 4EDM Notches at 0.1mm, 0.2mm, 0.3mm and 0.4mm deep x 0.5mm wide x25.0mm long